Add scaling parameters to FRER. Note, that many of the suggested
objects are modeled the same ways as the VLAN-related objects
maxVlanId, maxSupportedVlans and NumVlans (IEEE 802.1Q-2018, clause
Insert the following item in the itemized list in clause 10 after
item a) and before item b), renumbering as appropriate:
"b) The implementation specific Frame Replication and Elimination for
Reliability (FRER) Parameters (9.4) that are exposed for inspection by
(and alignment of) network management entities."
Insert the following subclauses after clause 10.1 and before clause
10.2, renumbering as appropriate:
"10.2 Frame Replication and Elimination for Reliability Parameters
The Frame Replication and Elimination for Reliability Parameters
summarize a set of management objects that expose the properties of an
NOTE: For the Sequence identification table no dedicated limits are
necessary, as the number of entries is determined indirectly by the
number of ports and the number of possible directions. It is not
possible that different encapsulation types are used on the same port.
The supported length of the Sequence generation table.
The number of currently configured Seqnece generation entries Seqeuence
The supported length of the Sequence recovery table.
The number of currently configured Seqnece recovery entries Seqeuence
The list of sequence recovery algorithms supported by this device.
The maximum history length for the vector recovery algorithm this
device supports. If this device does not support vector recovery
(10.2.7), this parameter should be set to 0.
The maximum reset timeout for the sequence recovery function expressed
in units of milliseconds supported by this device.
The list of sequence encapsulation types supported by this device.
A boolean value indicating if autoconfiguration is supported by this
A boolean value indicating if the stream split table (10.6) is
supported by this device.
A boolean value indicating if latent error detection is supported by
The list of ports on which FRER is supported, i.e., which can be
configured in frerSeqRcvyPortList (10.4.1.2), frerSeqEncPort (10.5.1.2),
frerSplitPort (10.6.1.1), frerAutSeqReceivePortList (10.7.1.1.2),
frerAutSeqRecoveryPortList (10.7.1.1.5), or frerAutOutPortList